Proudly Sponsored by...

GuitarSite.com
Discussion
Forum

Re: Fender Telesonic

[ Follow Ups ] [ Post Followup ] [ Guitarist Discussion Forum ]

Posted by Neil Tevepaugh (from: ) on April 27, 2002 at 10:57:59:

In Reply to: Fender Telesonic posted by Chris Watkins on March 28, 2002 at 12:28:07:

: Does anyone kow how to adjust the action on a fender telesonic with its wilkinson stop tail bridge.Fender UK said use the neck tilt.How do you do adjust this,it isn't in the manual you get with the guitar.

You might want to check the Fender web site under Resources/Mr GearHead Product Support/Fender/5 Steps to a Great Guitar setup. I would think messing with the neck tilt should not be your starting point Should you decide to do so, the adjustment point is at the back plate where the neck is attached. You will find a small hole in the neck plate where a hex wrench can be used to adjust the tilt. Note that is call a micro adjustment. Be sure to loosen your strings prio to proceeding. Again, you must be sure that the neck is adjusted and that bridge height has been adjusted.

Neil

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: : Does anyone kow how to adjust the action on a fender telesonic with its wilkinson stop tail bridge.Fender UK said use the neck tilt.How do you do adjust this,it isn't in the manual you get with the guitar. : You might want to check the Fender web site under Resources/Mr GearHead Product Support/Fender/5 Steps to a Great Guitar setup. I would think messing with the neck tilt should not be your starting point Should you decide to do so, the adjustment point is at the back plate where the neck is attached. You will find a small hole in the neck plate where a hex wrench can be used to adjust the tilt. Note that is call a micro adjustment. Be sure to loosen your strings prio to proceeding. Again, you must be sure that the neck is adjusted and that bridge height has been adjusted. : Neil

[ Follow Ups ] [ Post Followup ] [ Guitarist Discussion Forum ]