- This topic has 2 replies, 1 voice, and was last updated 23 years, 2 months ago by .
-
Topic
-
Hi Guys,
I recently bought a new used TriAxis (2.0) without the manual.
I downloaded the TriAxis manual from M.B, and the first thing I
wanted to do was resetting it to show me the factory resets. This
should be achievable by pressing >shift< and then >mode<. I pressed
the key combination several times but nothing happened (I can’t
really tell whether it is reset, as the factory preset table in the back
of the manual appears to be for the 1.0 model and not the 2.0).However, I have a couple of times during programming experienced
that the LEDs in the preset and the program windows just went blank
and after a couple of seconds the unit is reset (rebooted). It is more
or less exactly what I would expect to happen by pressing >shift<
and then >mode<. I haven’t so far been able to find a reproducible way
to make this "resetting" appear, and in all other respects the unit seems
to work perfectly. (And I really do mean PERFECTLY!).Is my unit defective? Have the reset key sequence been changed?
Can anyone explain the reboot I’m experiencing?Best regards,
Vagn
- You must be logged in to reply to this topic.